This is a good question and you've already found the perfect place to get it answered. you'll find hundreds of successful suggestions on how to break in your vehicle. here's what we would recommend:
for an automatic, let it idle for at least 20 minutes in neutral without stopping
for a manual, drive around in 2nd or 3rd gear for 30 minutes and don't bring the rpms up beyond 3500 rpm for at least 15 seconds when making shifts
to avoid damaging your engine, turn off after 10-15 minutes of running.
consider getting an oil change before starting with these exercises
what is the best way to break-in a new car?
frequently take the vehicle on long trips that cover both rough and smooth surfaces.
advice for breaking in a new car can be found online, but what it mostly boils down to is “something like 20 hours of spirited driving (think country roads with hills instead of launching your m5) before operating on both tough and smooth conditions.” depending on where you live, it may be wise to include everything from potholes to highways in this break-in process. but don't worry; by following these few steps, you'll soon find yourself cruising along that scenic california coast again!
the best way to break-in a new car is by taking frequent long drives that cover over both rough and smooth surfaces. this will
do you need to break-in a car?
when a car is new, it is important to be gentle with your engine. if you drive too hard, you drive up the speeds or speeds go higher than motor can handle for that particular rpm range.
this causes the engine to work harder and in turn overheat and wear out quickly. if you were driving a more expensive car with an 8 cylinder motor, there's no problem idling at 2500 rpm or even slowly accelerating at 60 ou of 100 miles per hour… but if you suddenly did this on an old style 4 cylinder (either gas or diesel) automatic gearbox/clutch system then your engine would overheat almost immediately because it cannot cope with such low rpms without revving up into that more critical ”
how do you break-in a car engine?
engine break-in is the process of running an engine at speeds below 5,000 rpm or so in order to wear its parts in a controlled manner so they reach peak operating performance sooner.
the best way to safely break in your engine for optimal performance is with a regimen that restricts your vehicle speed and promotes gradual acceleration and deceleration over the course of 500 miles (805 km).
car engines usually need 500 miles or 5,000 – 20 000 kilometers of driving before they're “broken in” and start giving their best fuel economy numbers. at this point, it's also time for an oil change by following these steps: get more frequent oil changes after 25,000 miles or 50 400 kilometers. in between
how do you know when to break-in a car?
if you're breaking in an engine, it's important that the process is done gradually. this applies not just to how much it’s used but also to how long the car goes without being run every now and then. it's recommended that you don't drive your engine for more than 50 miles before giving it a break for 10 – 12 hours. doing so too soon or too often could cause damage. it's also necessary to use both city and highway mileage if you want an even running time, as this way the gas has time to dissolve moisture evenly– water doesn't mix well with oil and can cause issues if there is unequal distribution of moisture within your engine over time. in addition, during the break-in
