There are many ways to remove a dent from a car, but the best method depends on the size and location of the damage.
in professional auto body work, there are specialty equipment for small-to-medium sized dents called “punching.” this technique involves using a metal hammer with a sharp tool at its distal end. packed tightly against the surface surrounding the dent, it loosens any impacted material until it pops out easily– just like popping a pimple. if you have patches of paint hanging off or if you're going to do more extensive repairs that might involve taking down metal panels later on, consider asking an auto body shop about insurance prepositions for these repairs before undertaking this task. the last
how can i remove dents from my car at home?
if the dent is so deep that you need to go through to metal, then you are looking at doing some work. you'll want to start off by getting your hands on a putty knife, rubber mallet, and ice cubes (yes! ice cubes!). the chilling bit will really come in handy when it comes time to pop out the dent. once it's all good and chilled, take the putty knife (holding its edge with your fingers) and place flat against one side of the dent or crease leaving enough space for either your index finger or thumb. with pressure from constant tapping with your hammer (in short jerky movements) make sure this area is completely flat again. using lukewarm water (use
how do you pop a dent out of a car?
you should probably save your money and see if you can get it fixed by insurance or through any other means. pops dents out of cars by pushing them back inside the panel with a large screwdriver, playing around with it until it's popped out to an extent that its middle is about even with the size of the dent. the next step involves drilling two holes near the top lip of this push-pop dent that will act as enpoints to twist on pop bumper screws -– which are typically 1/4 inch long bolts. pop bumper screws are used for bumpers on trucks, but work fine in these instances too well. you'll also need four drill bit sizes: 3/16th, 7/32nd
how much does it cost to remove a dent in my car?
it depends. typically, dent removal using a can of compressed air can range anywhere from $100 to $300. a more expensive repair may be required if the repair material does not work on your particular type of damage.
sometimes repairing dents is not an option for insurance companies, so they may refuse to pay for repairs or accuse you of trying to fake damage that was already on your car before the accident. this is why it's always best to do any legal cost-benefit analyses with some sort of lawyer first before proceeding with any repairs after an accident.
can small dents be removed from cars?
small dents can be a pain. but a good dent repairman should have no problem, as long as you take your car to him right away. determine first if the damage is on the exterior or interior of the car. if it is on the exterior trim(s) and panels, then you will need an exterior specialist. interior work requires some knowledge of how cars are built and some experience with this type of work. it can be done by those lacking those skills but may not give satisfactory results in some cases because there are too many small components that need to go back together just right for everything to look normal – and they sometimes don't want to play along with somebody unfamiliar with all their secrets! finally
